Simple Built-in MPPT Solar Inverter for Hybrid Solar System
Home » Products » Off Grid Solar Inverter » HMK PLUS » Simple Built-in MPPT Solar Inverter for Hybrid Solar System

loading

Simple Built-in MPPT Solar Inverter for Hybrid Solar System

  • HMK PLUS

  • Hinvert

  • 1500-5500W

  • 230 VAC

  • 170-280 VAC (For Personal Computers) /90-280 VAC (For Home Appliances)

  • 50 Hz/60 Hz (Auto sensing)

  • 3000-11000VA

  • 10 ms (For Personal Computers) ; 20 ms (For Home Appliances)

  • single output

  • Pure sine wave

  • 12/24/48VDC

  • YES

  • 2000-6000W

  • 80/120A

  • 98%

Availability:

About Hinvert

Hinvert is a renewable energy company that is focused on designing & manufacturing inverter charger, solar inverter, solar panel and other green energy products. We have been in the inverter field for more than 10 years, and we aim to provide high quality inverters and good service to every customer! If you're trying to build solar system for your RV and off-grid home, we are your best choice !

5000 watt DC 48 volt solar inverter’s conversion time between bypass and inverter is 10ms; Rated input voltage 110/120Vac, Frequency 50Hz/ 60Hz (Auto detection); Efficiency >95%(AC mode), Efficiency >90%(Inverter mode), PV voltage range 120-500Vdc, PV maximum output power 5000W.

Simple Built-in MPPT Solar Inverter for Hybrid Solar System

Three Output Modes

PV priority mode: Switch to mains supply when the PV charging fails. This mode maximizes the use of solar energy while maintaining battery power, suitable for use in the areas with relatively stable grid.

Mains priority mode: Switch to inverter only when the mains fails (when there was mains power, switch to mains power for charging and power supply). Then, the unit is equivalent to a backup UPS, suitable for areas with unstable grid. Switching does not affect PV charging.

Inverter priority mode: Switch to mains supply only when the battery discharge under voltage is lower than the set point (item 04). When the charging battery is higher than the set point of (05 setting item), switch to the battery discharge mode. This can cycle the battery charge and discharge. This mode maximizes the use of DC power and is used in the area with stable grid. Switching does not affect PV charging.

Notes:


  1. This solar inverter is off grid inverter. It can not be used in parallel.

  2. This pure sine wave inverter can only used for 48V solar system.

  3. Optional WiFi/GPRS remote monitoring need extra cost.

Simple Built-in MPPT Solar Inverter for Hybrid Solar System

Previous: 
Next: 

Product Category

Support

Company

Contact Us

 fangjing@hinverter.com
  +86-133 0297 1039
 9/F, Jinyuanxing Hi-tech Industrial Park, No.6 Industrial Zone, Mashantou Community, Matian Street, Guangming District, Shenzhen, China
Copyright © 2022 Shenzhen Hinvert Electronics Co., Ltd. All Rights Reserved. Sitemap | Support By Leadong